This emergency light has the following two advantages:
1. It turns on automatically when the mains power fails, so you need not search it in the dark.
1. It turns on automatically when the mains power fails, so you need not search it in the dark.
2. Its battery starts charging as soon as the mains resumes.
Operation of the circuit is quite straightforward. Mains supply is stepped down by transformer X1, rectified by a full-wave rectifier comprising diodes D1 and D2, filtered by capacitor C1 and fed to relay coil RL1. The relay energises to connect the bat-tery to the charging circuit through its normally-opened (N/O) contacts. Free-wheeling diode D3 acts as a spike buster for the relay.
Operation of the circuit is quite straightforward. Mains supply is stepped down by transformer X1, rectified by a full-wave rectifier comprising diodes D1 and D2, filtered by capacitor C1 and fed to relay coil RL1. The relay energises to connect the bat-tery to the charging circuit through its normally-opened (N/O) contacts. Free-wheeling diode D3 acts as a spike buster for the relay.
The charging circuit is built around npn transistor BD139 (T1). The trans-former output is fed to the collector of transistor T1, which provides a fixed bias voltage of 6.8V to charge the battery. When the battery is fully charged, the battery voltage becomes equal to the breakdown voltage of the zener diode (ZD1). Zener diode ZD1 conducts to provide an alternative path for the current to ground and battery charging stops.
When mains fails, relay RL1 de-energizes. The battery now gets connected to the white LED array (comprising LED1 through LED6) through current-limiting resistor R2. The LEDs glow to light up the room. To increase the brightness in your room, you can increase the number of white LEDs after reducing the value of resistor R2 and also use a reflector assembly.
When mains fails, relay RL1 de-energizes. The battery now gets connected to the white LED array (comprising LED1 through LED6) through current-limiting resistor R2. The LEDs glow to light up the room. To increase the brightness in your room, you can increase the number of white LEDs after reducing the value of resistor R2 and also use a reflector assembly.
What if the battery changes to 12v 7Ah. need to change the transformer and zener. Is there anything else to change ?.
ReplyDeleteNo other things need to change, but check for the relay also, since some of the old ones may not work.
Delete